In order to achieve its maximum molding productivities , simply using its ultra micro breathing cell to exhale gas and air from molds.
Common questions:
1.burnt:
When aberration and burnt issues occurrcd , it is because resin is filling faster than air exhaling which will result gasven to overheat.
2.overflow:
There are 2 possible conditions:
ㆍ When temperature of resin gets higher at the tip of seaming, it weakens its bonding strength.
ㆍAir can filled up the path and blocks resin to flow functionallu which will cause ejection pressure to rise and materials to overflow.
3.Not enough fillings:
Due to air pressure , it reduces the ratio of the filling speed.even there is no any sign of burnt or overflow.
4.Cell streak:
If there are some cells , streaks and mottles occurred , it is because the cells have not been vaporized completely between air and resin.
5. Extensive Cycling Time:
The higher temperature of resin,molds and slower speed of injection cause extensive cycling time, however, it will not a ffect the quality of
final products.
Enerty,time and cost savar:
1. It will reduce the trial die,time and materials if users consider to use TX gasvent the beginning of the design.
2. It will save up to 1/3 to 1/10 of the total cost and time if installing gasvent
Installation:
1. Do not touch the surface when gasvent is in use.
2. Use H7/s6 from JIS reference chart.
